Main shaft stops control definitely

  • Time:
  • Click:78
  • source:GAENOR CNC Machining
One, the notional main shaft that main shaft stops definitely stops a function definitely (say again: Function of main shaft fixed position) , stop when main shaft namely when, control its to stop at securing the position. Main application changes knife control at machining center, essence of life bores hole retreat the circumstance such as the knife. Next graphs stop definitely for main shaft bore hole sketch map. 2, machine stays control definitely 1.

Systematic composition: Typical V form groovy annulus locates dish halt a construction definitely. 2.

Stay control course definitely: Main shaft decelerate comes some is OK the low speed of set is rotational, after without contact switch effective signal is detected, make main shaft electromotor stops to turn and disconnect instantly advocate transmission catenary, stop oil cylinder fixed position to sell definitely at the same time extend and press to fixed position dish. When should locating groove and fixed position sell dish of V form to be opposite, fixed position is sold in inserting V form chamfer, stop signal definitely effective, make clear stop a movement to finish definitely. 3, electric stop the advantage that commands electric control to stop definitely definitely: (1) rigid structure simplifies (2) stop time to shorten definitely (3) dependability increases (4) sexual price is more advanced than carrying. 1.

Magnetism sensor stop definitely 1) the system comprises Nextpage 2) stop control process to stop control to be finished by main shaft actuating device definitely definitely. 2.

Coder stop definitely 1) the system is comprised 2) stop control process to stop control to be finished by main shaft actuating device definitely definitely, flexibility compares magnetism sensor model had stopped definitely. 3.

Numerical control system stop definitely 1) the system is comprised 2) stopping control process to stop control definitely definitely is finish by numerical control system, when using means of this kind of control, numerical control system must have function of main shaft closed-loop control, the control principle that main shaft stops definitely and principle of feed position pilot are very similar. CNC Milling CNC Machining